Описание товара
Подробности
Цифровой удлинитель сигнала по витой паре совместим с линейкой продуктов Extron DTP™, обеспечиваени передачу DVI‑D видео, аудио и двух-стороннего RS‑232 и ИК сигналов на расстоянени до 70 метров (230 feet) по экранированному кабелю CATx.
- Принимает DVI-D плюс управление и аналоговое аудио на растояние до 70 метров
- Поддерживает компьютерную графику и видео с разрешением до 4K, включая 1080p/60 Deep Color
- Совместимость с экранированными кабелями CATx
- Рекомендуется использовать экранированный кабель Extron XTP DTP 24
Дополнительная информация
Video | |||
---|---|---|---|
Maximum data rate | 10.2 Gbps (3.4 Gbps per color) | ||
Maximum pixel clock | 300 MHz | ||
Resolution range | Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling (* reduced blanking) | ||
Color bit depth | 8, 10, or 12 bits — subject to the maximum data rate limit | ||
Formats | RGB and YCbCr digital video | ||
Standards | DVI 1.0, HDMI, HDCP 1.1, CEA-861E | ||
Video input — transmitter | |||
Number/signal type | 1 single link DVI-D (or HDMI*) input 1 single link DVI-D (or HDMI*) local loop-through | ||
Connectors | 2 female DVI-I | ||
Interconnection between transmitter and receiver | |||
Connectors | 1 female RJ-45 per unit | ||
Termination standard | TIA/EIA T568B | ||
Signal transmission distance | |||
1080p @ 60 Hz | Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
2560x1600 @ 60 Hz | Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
4K/UHD @ 30Hz and 60 Hz | Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
Cable requirements | Solid conductor, 24 AWG or better | ||
Cable recommendations | 400 MHz bandwidth, STP (shielded twisted pair) | ||
| |||
Video output — receiver | |||
Number/signal type | 1 single link DVI-D (or HDMI*) | ||
Connectors | 1 female DVI-I | ||
Audio | |||
Gain | Unbalanced output: 0 dB; balanced output +6 dB | ||
Frequency response | 20 Hz to 20 kHz, ±0.5 dB | ||
THD + Noise | 0.03% @ 20 Hz to 20 kHz at maximum output | ||
S/N | >90 dB, at maximum output (15 dBu), balanced (unweighted) | ||
Stereo channel separation | >80 dB @ 1 kHz to 20 kHz | ||
Audio input | |||
Number/signal type | 1 PC level stereo, unbalanced | ||
| |||
Connectors | (1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground) | ||
Impedance | >10k ohms, DC coupled | ||
Nominal level | -10 dBV (316 mVrms) | ||
Maximum level | +7 dBV (unbalanced) | ||
| |||
Audio output | |||
Number/signal type | 1 stereo (2 channel), balanced/unbalanced | ||
Connectors | (1) 3.5 mm captive screw connector, 5 pole | ||
Impedance | 50 ohms unbalanced, 100 ohms balanced | ||
Gain error | ±0.1 dB channel to channel | ||
Maximum level (600 ohm) | >+11 dBu, balanced | ||
Communications — external device (pass-through, unidirectional or bidirectional) | |||
Serial control port input/output | |||
Transmitter | RS-232 via (1) 3.5 mm, 5 pole captive screw connector for RS-232 control (±5 V) (connector is shared with IR control port) | ||
Receiver | 1 set of proprietary signals on a female RJ-45 jack | ||
Serial control port output/input | |||
Transmitter | 1 set of proprietary signals on a female RJ-45 jack | ||
Receiver | RS-232 via a 3.5 mm, 3 pole captive screw connector | ||
Baud rates | Up to 115200 baud | ||
Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none | ||
Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = GND | ||
IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz | ||
IR control pin configuration | 3 = GND, 4 = IR Tx, 5 = IR Rx | ||
General | |||
Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts | ||
Power consumption | |||
Transmitter | |||
Device | 3.4 watts, 12 VDC | ||
Device and power supply | 4.8 watts, 100-240 VAC, 50-60 Hz | ||
Receiver | |||
Device | 4.2 watts, 12 VDC | ||
Device and power supply | 5.8 watts, 100-240 VAC, 50-60 Hz | ||
| |||
Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing | ||
Cooling | Convection, no vents | ||
Thermal dissipation | |||
Transmitter | |||
Device | 10.3 BTU/hr | ||
Device and power supply | 15.1 BTU/hr | ||
Receiver | |||
Device | 13.0 BTU/hr | ||
Device and power supply | 18.6 BTU/hr | ||
Mounting | |||
Rack mount | Yes, with optional 1U high rack shelf | ||
Furniture mount | Yes, with optional under-desk mounting kit | ||
Enclosure type | Metal | ||
Enclosure dimensions | |||
Transmitter | 1.0" H x 4.3" W x 3.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) | ||
Receiver | 1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 15.2 cm D) (Depth excludes connectors.) | ||
Product weight | |||
Transmitter | 0.5 lbs (0.3 kg) | ||
Receiver | 1.0 lb (0.5 kg) | ||
Shipping weight | 3 lbs (2 kg) | ||
Vibration | ISTA 1A in carton (International Safe Transit Association) |