Описание товара
Подробности
Передатчик на длинные дистанции видеосигнала DVI-D, а также двунаправленных сигналов управления по одному кабелю типа CAT 5. Для обеспечения дополнительной универсальности и удобства возможна также передача раздельных аналоговых стереофонических аудио сигналов по второй витой паре. Комплект способен передавать сигналы 1080p/60 Deep Color и 1920x1200 на расстояние до 100 м. Для обеспечения дополнительной универсальности и удобства передатчик оснащен выходом с буфером сквозного канала DVI для поддержки локального компьютерного монитора.
- Передача SingleLink сигнала DVI-D, а также сигналов RS-232 и ИК по одному кабелю типа CATx
- Распространение сигналов 1080p/60 Deep Color и 1920x1200 на расстояние до 100 м
- Передача раздельных стереофонических аудио сигналов
- Сквозной вход DVI
- Поддержка передачи DDC и HDCP
- Дистанционное электропитание передатчика или приемника
Дополнительная информация
| Video | |||
|---|---|---|---|
| Maximum data rate | 6.75 Gbps (2.25 Gbps per color) | ||
| Maximum pixel clock | 165 MHz | ||
| Resolution range | Up to 1920x1200 or 1080p @ 60 Hz; 8, 10, or 12 bit color depth | ||
| Formats | RGB and YCbCr digital video | ||
| Standards | DVI 1.0, HDMI | ||
| Video input and loop-through — transmitter | |||
| Number/signal type | 1 single link DVI-D (or HDMI*) input 1 single link DVI-D (or HDMI*) local loop-through | ||
| Connectors | 2 female DVI-I | ||
| Interconnection between transmitter and receiver | |||
| Connectors | 2 female RJ-45 per unit for 2 cables connecting the transmitter and receiver TP1 output transmits digital video, embedded digital audio, RS-232, IR, and remote power. TP2 output transmits analog stereo audio. | ||
| Termination standards | TIA/EIA T568A or T568B | ||
| Signal transmission distance | 330' (100 m) using CAT 5e/6/7 UTP or STP cable (24 AWG or better) | ||
| Video output — receiver | |||
| Number/signal type | 1 single link DVI-D (or HDMI*) | ||
| Connectors | 1 female DVI-I | ||
| Audio | |||
| Gain | Unbalanced output: 0 dB; balanced output +6 dB | ||
| Frequency response | 20 Hz to 20 kHz, ±0.05 dB | ||
| THD + Noise | 0.03% @ 20 Hz to 20 kHz at maximum output | ||
| S/N | >90 dB, at maximum output (15 dBu), balanced (unweighted) | ||
| Stereo channel separation | >80 dB @ 1 kHz to 20 kHz | ||
| Audio input | |||
| Number/signal type | 1 PC level stereo, unbalanced | ||
| Connectors | (1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground) | ||
| Impedance | >10k ohms, DC coupled | ||
| Nominal level | -10 dBV (316 mVrms) | ||
| Maximum level | +7 dBV (unbalanced) | ||
| |||
| Audio output | |||
| Number/signal type | 1 stereo (2 channel), balanced/unbalanced | ||
| Connectors | (1) 3.5 mm captive screw connector, 5 pole | ||
| Impedance | 50 ohms unbalanced, 100 ohms balanced | ||
| Gain error | ±0.1 dB channel to channel | ||
| Maximum level (600 ohm) | >+15 dBu, balanced | ||
| Control/remote — external device (pass-through, unidirectional or bidirectional) | |||
| Serial control port input/output | |||
| Transmitter | RS-232 via (1) 3.5 mm, 5 pole captive screw connector for RS-232 control (±5 V) (connector is shared with IR control port) | ||
| Receiver | 1 set of proprietary signals on a female RJ-45 jack | ||
| Serial control port output/input | |||
| Transmitter | 1 set of proprietary signals on a female RJ-45 jack | ||
| Receiver | RS-232 via a 3.5 mm, 3 pole captive screw connector | ||
| Baud rates | Up to 115200 baud | ||
| Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none | ||
| Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = GND | ||
| IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz | ||
| IR control pin configuration | 3 = GND, 4 = IR Tx, 5 = IR Rx | ||
| General | |||
| Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts | ||
| Power consumption | 7.6 watts, 12 VDC, total, for both transmitter and receiver | ||
| |||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing | ||
| Cooling | Convection, no vents | ||
| Mounting | |||
| Rack mount | Yes, with optional 1U high rack shelf | ||
| Furniture mount | Yes, with optional under-desk mounting kit | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | |||
| Transmitter | 1.0" H x 4.3" W x 3.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) | ||
| Receiver | 1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 15.2 cm D) (Depth excludes connectors.) | ||
| Product weight | |||
| Transmitter | 0.5 lbs (0.3 kg) | ||
| Receiver | 1.0 lb (0.5 kg) | ||
| Shipping weight | 3 lbs (2 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
