Описание товара
Подробности
Передатчик Extron для передачи видео DVI‑D, аудио и двунаправленных сигналов RS‑232 и ИК на расстояние до 70 м устройствам Extron с поддержкой DTP® по одному экранированному кабелю CATx. Устройство обеспечивает экономичную и эффективную передачу сигналов формата Single Link DVI‑D или HDMI. Кроме того, DTP DVI 4K 230 Tx принимает сигналы аналогового стереоаудио для одновременной передачи по тому же экранированному кабелю витой пары. Он поддерживает видеосигналы с разрешением до 4K, в том числе 1080p/60 Deep Color. Передатчик имеет локальный выход DVI для поддержки локального монитора компьютера. Благодаря компактному размеру корпуса и возможности удалённого питания DTP DVI 4K 230 Tx является идеальным решением для незаметной установки на кафедрах, под столами или в любых других местах в соответствии с требованиями проекта.
- Передаёт сигналы Single Link DVI-D с сигналами управления и аналоговым аудио на расстояние до 70 м по экранированному кабелю CATx
- Поддержка видеоразрешений и компьютерных разрешений до 4K, в том числе 1080p/60 Deep Color
- Совместимость с экранированным кабелем витой пары CATx
- Настоятельно рекомендуется использовать кабель экранированной витой пары Extron XTP DTP 24 для оптимального функционирования системы
- Принимает дополнительное аналоговое стереоаудио
- Локальный выход DVI
Дополнительная информация
Video | |||
---|---|---|---|
Maximum data rate | 10.2 Gbps (3.4 Gbps per color) | ||
Maximum pixel clock | 300 MHz | ||
Resolution range | Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz, UHD (3840x2160) @ 30 Hz, 4K/UHD @ 60 Hz with 4:2:0 chroma subsampling (* reduced blanking) | ||
Color bit depth | 8, 10, or 12 bits — subject to the maximum data rate limit | ||
Formats | RGB and YCbCr digital video | ||
Standards | DVI 1.0, HDMI, HDCP 1.1, CEA-861E | ||
Video input — transmitter | |||
Number/signal type | 1 single link DVI-D (or HDMI*) input 1 single link DVI-D (or HDMI*) local loop-through | ||
Connectors | 2 female DVI-I | ||
Interconnection between transmitter and receiver | |||
Connectors | 1 female RJ-45 per unit | ||
Termination standard | TIA/EIA T568B | ||
Signal transmission distance | |||
1080p @ 60 Hz | Up to 230' (70 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
2560x1600 @ 60 Hz | Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
4K/UHD @ 30Hz and 60 Hz | Up to 130' (40 m) using shielded twisted pair (STP) cable or XTP DTP 24 STP cable | ||
Cable requirements | Solid conductor, 24 AWG or better | ||
Cable recommendations | 400 MHz bandwidth, STP (shielded twisted pair) | ||
| |||
Video output — receiver | |||
Number/signal type | 1 single link DVI-D (or HDMI*) | ||
Connectors | 1 female DVI-I | ||
Audio | |||
Gain | Unbalanced output: 0 dB; balanced output +6 dB | ||
Frequency response | 20 Hz to 20 kHz, ±0.5 dB | ||
THD + Noise | 0.03% @ 20 Hz to 20 kHz at maximum output | ||
S/N | >90 dB, at maximum output (15 dBu), balanced (unweighted) | ||
Stereo channel separation | >80 dB @ 1 kHz to 20 kHz | ||
Audio input | |||
Number/signal type | 1 PC level stereo, unbalanced | ||
| |||
Connectors | (1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground) | ||
Impedance | >10k ohms, DC coupled | ||
Nominal level | -10 dBV (316 mVrms) | ||
Maximum level | +7 dBV (unbalanced) | ||
| |||
Audio output | |||
Number/signal type | 1 stereo (2 channel), balanced/unbalanced | ||
Connectors | (1) 3.5 mm captive screw connector, 5 pole | ||
Impedance | 50 ohms unbalanced, 100 ohms balanced | ||
Gain error | ±0.1 dB channel to channel | ||
Maximum level (600 ohm) | >+11 dBu, balanced | ||
Communications — external device (pass-through, unidirectional or bidirectional) | |||
Serial control port input/output | |||
Transmitter | RS-232 via (1) 3.5 mm, 5 pole captive screw connector for RS-232 control (±5 V) (connector is shared with IR control port) | ||
Receiver | 1 set of proprietary signals on a female RJ-45 jack | ||
Serial control port output/input | |||
Transmitter | 1 set of proprietary signals on a female RJ-45 jack | ||
Receiver | RS-232 via a 3.5 mm, 3 pole captive screw connector | ||
Baud rates | Up to 115200 baud | ||
Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none | ||
Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = GND | ||
IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz | ||
IR control pin configuration | 3 = GND, 4 = IR Tx, 5 = IR Rx | ||
General | |||
Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts | ||
Power consumption | |||
Transmitter | |||
Device | 3.4 watts, 12 VDC | ||
Device and power supply | 4.8 watts, 100-240 VAC, 50-60 Hz | ||
Receiver | |||
Device | 4.2 watts, 12 VDC | ||
Device and power supply | 5.8 watts, 100-240 VAC, 50-60 Hz | ||
| |||
Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing | ||
Cooling | Convection, no vents | ||
Thermal dissipation | |||
Transmitter | |||
Device | 10.3 BTU/hr | ||
Device and power supply | 15.1 BTU/hr | ||
Receiver | |||
Device | 13.0 BTU/hr | ||
Device and power supply | 18.6 BTU/hr | ||
Mounting | |||
Rack mount | Yes, with optional 1U high rack shelf | ||
Furniture mount | Yes, with optional under-desk mounting kit | ||
Enclosure type | Metal | ||
Enclosure dimensions | |||
Transmitter | 1.0" H x 4.3" W x 3.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) | ||
Receiver | 1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 15.2 cm D) (Depth excludes connectors.) | ||
Product weight | |||
Transmitter | 0.5 lbs (0.3 kg) | ||
Receiver | 1.0 lb (0.5 kg) | ||
Shipping weight | 3 lbs (2 kg) | ||
Vibration | ISTA 1A in carton (International Safe Transit Association) |