Описание товара
Подробности
Четырехканальный светорегулятор. Предназначен для работы в составе системы управления Crestron. Автоматическое определение типа нагрузки и режима управления яркостью (по фазе/противофазе). Устройство работает с низковольтными обмоточными и электронными трансформаторами, лампами накаливания, лампами с холодным катодом, неоновыми лампами, двухконтактными люминесцентными лампами, способными изменять яркость свечения и нерегулируемыми лампами. Подключаемая нагрузка должна быть рассчитана на напряжение 120 или 220-240 В. Максимальная сила тока на канал - не более 5 А, на устройство - не более 10 А.
- 4 channels of forward or reverse phase dimming
- Auto load detection
- 120 to 240 Volt 50/60 Hz operation
- Selectable non-dim mode
- Extreme stability in noisy environments
- Short circuit and overload protection
- Master air-gap relay
- Override input
- Cresnet communications
- Setup via front panel or software
- Programmable functionality via DIN-AP2
- 12M wide DIN rail mounting
Дополнительная информация
Load Ratings | ||
Dimmer Channels | 4 | |
Maximum Per Channel | 5 Amps @ 120 to 240 Volts AC, 50/60 Hz; 600 Watts @ 120 Volts AC; 1150 Watts @ 230 Volts AC; 1200 Watts @ 240 Volts AC | |
Module Total | 10 Amps @ 120 to 240 Volts AC, 50/60 Hz; 1200 Watts @ 120 Volts AC; 2300 Watts @ 230 Volts AC; 2400 Watts @ 240 Volts AC | |
Load Types | Forward Phase (leading edge) or Reverse Phase (trailing edge) Electronic Low Voltage, Incandescent, Neon/Cold Cathode, Magnetic Low Voltage, Dimmable 2 Wire Fluorescent, & Non-Dim Lighting | |
Input Voltage | ||
Line Power | 120 to 240 Volts AC, 50/60 Hz | |
Connections | ||
NET | (2) 4-pin 3.5mm detachable terminal blocks, paralleled; Cresnet slave port | |
OVERRIDE | (2) 2-pin 3.5mm detachable terminal blocks, paralleled; Sensing input for external low-voltage contact closure; Activates override mode when a closure is present; Minimum Closure Rating: 10mA (per module) at 24 Volts | |
LIVE | (2) Captive screw terminals†, brown; Line power input | |
NEUTRAL | (5) Captive screw terminals†, blue | |
DIMMED LIVE 1 – 4 | (4) Captive screw terminals†, red; Dimmer channel outputs 1 - 4 | |
Ground | (5) Captive screw terminals†, green | |
Controls & Indicators | ||
NET ID | (2) 7-Segment green LED digits and (2) miniature pushbuttons for setting Cresnet ID; digits also display output levels and protection/error codes | |
SETUP | (1) Red LED and (1) recessed miniature pushbutton for enabling setup mode and touch-settable ID | |
OVR | (1) Red LED and (1) miniature pushbutton for enabling override mode and saving override presets | |
PWR | (1) Green LED, normally indicates AC line power is connected to either LIVE terminal, blinks when only powered by Cresnet | |
NET | (1) Yellow LED, indicates communication with the control processor | |
RESET | (1) Recessed miniature pushbutton, resets internal processor | |
FWD 1 – 4 | (4) Red LEDs, illuminate when a corresponding channel is operating in forward-phase mode | |
REV 1 – 4 | (4) Red LEDs, illuminate when a corresponding channel is operating in reverse-phase mode | |
AUTO 1 – 4 | (4) Red LEDs, illuminate when a corresponding channel is set to auto-detect the load type | |
NON-DIM 1 – 4 | (4) Red LEDs, illuminate when a corresponding channel is operating in non-dim mode | |
Channel Mode Select 1 – 4 | (4) Recessed miniature pushbuttons, used to select each channel’s operating mode | |
LOADS 1 – 4 | (4) Red LEDs and (4) miniature pushbuttons for status indication and local control of each channel | |
Enclosure | ||
Aluminum with polycarbonate label overlay, 35mm DIN EN 60715 rail mount, DIN 43880 form factor for enclosures with 45mm front panel cutout, occupies 12 DIN module spaces (216mm)* | ||
Power Requirements | ||
Cresnet Power Usage | 0.6 Watts (0.03 Amps @ 24 Volts DC) when line power is not available | |
Environmental | ||
Temperature | 32° to 104°F (0° to 40°C) | |
Humidity | 10% to 90% RH (non-condensing) | |
Heat Dissipation | 60 BTU/hr @240 Volts with 2 channels at 5 Amps; 50 BTU/hr @ 120 Volts with 2 channels at 5 Amps | |
Dimensions | ||
Height | 3.71 in (9.42 cm) | |
Width | 8.49 in (21.55 cm) | |
Depth | 2.35 in (5.95 cm) | |
Weight | ||
2.1 lb (912 g) |