Описание товара
Подробности
- Яркость 2700 ANSI лм
- Разрешение 1280x800
- Контрастность 4000:1
- Ручная коррекция трапецеидальных искажений +/- 40 градусов (по вертикали)
- Ресурс работы лампы до 10000 часов в режиме АВТО
- Режим установки цвета стены предоставляет выбор из пяти цветов (черная доска (темно-зеленая), белый, светло-желтый, светло-голубой, розовый], позволяющий легко проекцировать на различные поверхности
- Русское экранное меню
- Богатый набор интерфейсов, включая HDMI и два входа информации с компьютера
- Проектор поддерживает Crestron RoomView, что позволяет пользователям контролировать и управлять проекторами, подключенными к сети
- Встроенный динамик 8 Вт (моно)
- Тихий уровень шума 29 Дб не мешает проведению встреч и занятий в классах
- Защитная перекладина для защиты от кражи
- Система идентификации проектора для удаленного управления распределением до шести проекторов
- Интеллектуальная система управления лампы снижает энергопотребление
- Вес: 2,5 кг
Дополнительная информация
Power supply | 100-240 V AC, 50/60 Hz | |
Power consumption | 218 W (0.5 W when STANDBY MODE set to ECO,*1 6.0 W when STANDBY MODE set to NORMAL.*2) | |
DLP™ chip | Panel size | 14 mm (0.55 in) (4:3 aspect ratio) |
Display method | DLP™ chip x 1, DLP™ projection system | |
Pixels | 786,432 (1,024 x 768) pixels | |
Lens | 1.1x Manual zoom (1.95-2.15:1 throw ratio), manual focus, F 2.41-2.53, f=21.8-24 mm | |
Lamp | 190 W UHM lamp | |
Lamp replacement cycle(Normal / Eco1, Eco2 / AUTO) | 5,000 / 6,000 / 10,000 hours*3 | |
Screen size (diagonal) | 0.76-7.62 m (30-300 in), 4:3 aspect ratio | |
Brightness*⁴ | 2,700 lm | |
Center-to-corner uniformity*⁴ | 80 % | |
Contrast*⁴ | 4,000:1 (full on/full off, During RGB signal input, Color mode: Dynamic, Lamp power: Normal) | |
Resolution | 1,024 x 768 pixels (Input signals that exceed this resolution will be converted to 1,024 x 768 pixels.) | |
Scanning frequency | HDMI | fH: 15-91.1 kHz, fV: 24-85.1 Hz, dot clock: 25-162 MHz |
RGB (analog) | fH: 15-91.1 kHz, fV: 24-85.1 Hz, dot clock: 162 MHz or lower | |
YPBPR (YCBCR) | fH: 15.75 kHz, fV: 60 Hz [480i (525i)] fH: 31.50 kHz, fV: 60 Hz [480p (525p)] fH: 45.00 kHz, fV: 60 Hz [720 (750)/60p] fH: 33.75 kHz, fV: 60 Hz [1080 (1125)/60i] fH: 27.00 kHz, fV: 24 Hz [1080 (1125)/24p] fH: 56.25 kHz, fV: 50 Hz [1080 (1125)/50p] fH: 15.63 kHz, fV: 50 Hz [576i (625i)] fH: 31.25 kHz, fV: 50 Hz [576p (625p)] fH: 37.50 kHz, fV: 50 Hz [720 (750)/50p] fH: 28.13 kHz, fV: 50 Hz [1080 (1125)/50i] fH: 67.50 kHz, fV: 60 Hz [1080 (1125)/60p] | |
Video | fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60], fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM] | |
Optical axis shift | 10:-1.5 | |
Keystone correction range | Vertical: ±40° (manual) | |
Installation | Ceiling/floor, front/rear | |
Terminals | HDMI IN | HDMI 19-pin x 1 (Deep color, compatible with HDCP), audio signal: linear PCM (sampling frequency: 48 kHz, 44.1 kHz, 32 kHz) |
COMPUTER IN | D-sub HD 15-pin (female) x 1 [RGB/YPB(CB)/PR(CR) x 1] | |
MONITOR OUT | D-sub HD 15-pin (female) x 1 | |
VIDEO IN | Pin jack x 1 | |
SERIAL IN | Mini DIN 3-pin (female) x 1 for external control (RS-232C compliant) | |
AUDIO IN | M3 x 1 (L-R x 1) | |
AUDIO OUT | M3 x 1 (L-R x 1) for output (variable) | |
Built-in speaker | 4 x 2 cm oval shape x 1, output power 2 W (monaural) | |
Cabinet materials | Molded plastic (PC) | |
Dimensions (W x H x D) | 286 x 100.6*5 x 192 mm (11-1/4 x 3-31/32 x 7-9/16 in) | |
Weight | Approximately 2.3 kg (5.1 lbs)*6 | |
Operation noise*⁴ | 34 dB (Lamp power: Normal), 29 dB (Lamp power: Eco) | |
Operating temperature | 5-40°C [41-104°F] (Less than 750 m [2,500 ft] above sea level), 5-35°C [41-95°F] (between 750 and 1,500 m [2,500 ft and 5,000 ft] above sea level), 5-30°C [41-86°F] (between 1,500 and 3,000 m [5,000 ft and 10,000 ft] above sea level) | |
Operating humidity | 20-80 % (no condensation) | |
Supplied accessories | Power cord (1.8 m*7) x 1*8, wireless remote control unit x 1, lithium coin cell battery x 1, computer cable (1.8 m) x 1 | |
NOTE | * Product numbers vary depending on the market. The general guideline is as follows: The product number in the Americas and Taiwan is PT-LX300U and PT-LX270U. The product number in Europe (except the UK) and CIS is PT-LX300E and PT-LX270E. The product number in the UK, Asia (except Taiwan), Oceania, Middle East, and Africa is PT-LX300EA and PT-LX270EA. *1 When [VGA Out (Standby)] / [In Standby Mode (Audio)] are all set to [Off]. *2 When [VGA Out (Standby)] / [In Standby Mode (Audio)] are all set to [On]. *3 This is the maximum value when the lamp is turned on for 2 hours and off for 0.25 hours. If the lamp is turned on more times or kept on for a long time, the lamp replacement cycle will shorten. The usage environment affects the duration of the lamp. *4 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards. *5 With legs at shortest position. *6 The above values are averages. Actual values may be different according to the product. *7 Power cord (2 m) for the PT-LX300U/LX270U. *8 Power code (x2) for the PT-LX300EA/LX270EA. NOTES ON USE 1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping sound, or fail to illuminate, due to impact or extended use. 2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions: • Never place objects on top of the projector while it is in operation. • Make sure there is an unobstructed space of 1,000 mm (3 ft 3 in) or more around the projector’s exhaust openings. • If stacking projector units, care must be taken to provide the recommended space between units. These space requirements also apply to installation where only one projector unit is operating at one time and the other unit is used as a backup. • If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the operating temperature listed in the specifications table during use. Also, make sure the projector’s intake and exhaust openings are not blocked. Ensure there is sufficient ventilation to prevent hot air from the exhaust openings being recirculated into the intake opening. 3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods. • The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions. • The brightness of the lamp will gradually decrease with use. 4 Due to natural characteristics of lamps, screen brightness may fluctuate. This is not an indication of faulty lamp performance. |