Описание товара
Подробности
Процессор автоматизации DIN-AP2 2-й серии создан для небольших и средних инсталяций по управлению светом и других приложений автоматизации помещений. Монтаж на рейку DIN позволяет использовать его с другими модулям управления Crestron DIN Rail. Два порта RS-232 COM и четыре порта IR/serial, позволяют интегировать любые устройства в сеть управления от простых штор до продвинутых систем безопаности.
- Процессор 2-й серии
- Слот расширения памяти MMC
- Cresnet порт - настраиваемый master/slave
- 10/100 Ethernet | SSL шифрование
- Поддержка e-Control 2, SNMP, & RoomView
- 2 порта RS-232 COM
- 4 порта IR/serial
- 8 портов Versiport I/O
- 4 порта Low-voltage relay
- Конфигурация и настройка в ПО Crestron D3 Pro
- Монтаж 9M DIN
- Необходим внешний блок питания
- Совместимость EMerge Alliance®
Дополнительная информация
| Processor | ||
| CPU | 32-bit Freescale ColdFire® Microprocessor | |
| Memory | ||
| SDRAM | 32 MB | |
| NVRAM | 256 KB | |
| Flash | 8 MB | |
| Memory Card | expandable up to 2 GB using MMC compatible card (not included) | |
| Operating System | ||
| Real-time, preemptive multi-threaded/multitasking kernel; FAT32 file system with long names; supports SIMPL™ Windows® and SIMPL+® | ||
| Ethernet | ||
| 10/100BaseT, auto-negotiating, full/half duplex, static IP or DHCP/DNS, SSL, TCP/IP, UDP/IP, CIP, SMTP, SNMP, built-in Web server and e-mail client; supports Crestron e-Control®2 XPanel and RoomView™ applications | ||
| Connectors | ||
| I/O 1 – 8 | (1) 9-pin 3.5mm detachable terminal block comprising (8) digital input/output or analog input ports (referenced to GND); Digital Input: Rated for 0-24 Volts DC, input impedance 20k ohms, logic threshold 1.25 Volts DC; Digital Output: 250 mA sink from maximum 24 Volts DC, catch diodes for use with “real world” loads; Analog Input: Rated for 0-10 Volts DC, protected to 24 Volts DC maximum, input impedance 20k ohms; Programmable 5 Volts, 2k ohms pull-up resistor per pin | |
| RELAYS 1 – 4 | (1) 8-pin 3.5mm detachable terminal block comprising (4) normally open, isolated relays; Rated 1 Amp, 30 Volts AC/DC; MOV arc suppression across contacts | |
| COMPUTER | (1) USB Type B female, USB 1.1 computer console port | |
| NET | (2) 4-pin 3.5mm detachable terminal blocks, paralleled; Cresnet port and 24 Volt DC power input Master/Slave selectable | |
| COM 1 – 2 | (2) 5-pin 3.5mm detachable terminal blocks Bidirectional RS-232 ports; Up to 115.2k baud; hardware and software handshaking support | |
| LAN | (1) 8-wire RJ45 with 2 LED indicators; 10/100BaseT Ethernet port; Green LED indicates link status; Yellow LED indicates Ethernet activity | |
| IR/SERIAL 1 – 4 | (1) 8-pin 3.5mm detachable terminal block comprising (4) IR/Serial output ports; IR output up to 1.2 MHz; 1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud; Individual signal generator per port, allowing simultaneous firing of all ports | |
| MEMORY | (1) MMC compatible card slot; Accepts Multimedia Memory Card (MMC) up to 2 GB | |
| Reset Buttons | ||
| HW-R | (1) Recessed miniature pushbutton for hardware reset (reboots the processor) | |
| SW-R | (1) Recessed miniature pushbutton for software reset (restarts the SIMPL program) | |
| LED Indicators | ||
| POWER | (1 green) Indicates power supplied to unit via either NET port | |
| NET | (1 yellow) Indicates Cresnet bus activity | |
| MSG | (1 red) Indicates processor has generated an error message | |
| Power Requirements | ||
| Cresnet Power Usage | 8 Watts (0.33 Amps @ 24 Volts DC) | |
| Environmental | ||
| Temperature | 32° to 104 °F (0° to 40 °C) | |
| Humidity | 10% to 90% RH (non-condensing) | |
| Heat Dissipation | 26 BTU/Hr | |
| Enclosure | ||
| Light gray polycarbonate housing with polycarbonate label overlay, UL94 V-0 rated, 35mm DIN EN 60715 rail mount, DIN 43880 form factor for enclosures with 45mm front panel cutout, occupies 9 DIN module spaces (162mm) | ||
| Dimensions | ||
| Height | 3.71 in (9.42 cm) | |
| Width | 6.26 in (15.90 cm) | |
| Depth | 2.28 in (5.80 cm) | |
| Weight | ||
| 9.8 oz (277 g) | ||
