Описание товара
Подробности
Affordable yet powerful, MC2W is a Crestron 2-Series control system processor featuring built-in control ports and a 1-way RF wireless gateway.
- 2-Series engine
- Cresnet port - master/slave selectable
- 2 Com ports (RS-232/422/485)
- 4 IR/serial ports
- 4 Versiport I/O ports
- 4 Low-voltage relay ports
- Built-in 1-way RF wireless gateway
- IR wireless compatible using CNXRMIRD
- External power pack included
- Single-space EIA rack-mountable
Дополнительная информация
Memory | ||
SDRAM | 32 MB | |
NVRAM | 256 KB | |
Flash | 4 MB | |
Operating System | ||
Real-time, preemptive multi-threaded/multitasking kernel; FAT32 file system with long names; supports SIMPL Windows™ and SIMPL+® | ||
Wireless | ||
RF Receiver | Selectable 433.92 (433) or 418 MHz 1-way RF | |
Device Compatibility, 433 MHz | Supports up to 256 WPR-48 or CNRFHT remotes, or up to 16 ST-1550C or ST-1700Ctouch panels | |
Device Compatibility, 418 MHz | Supports up to 256 WPR-48 remotes, or up to 16 ML-600 or MT-1000C remotes | |
Range | Up to 300 feet typical, subject to site-specific conditions and individual device capabilities [1] | |
Minimum distance allowed between MC2Ws/gateways is 50 feet | ||
Connectors | ||
COM A - B | (2) DB9 male, bidirectional RS-232/422/485 ports; Up to 115.2k baud; Hardware and software handshaking support; All ports support C2N-NPA8 Network Poll Accelerator | |
INFRARED-SERIAL OUTPUT A - D | (4) 2-pin 3.5mm detachable terminal blocks, IR/Serial output ports; IR output up to 1.2 MHz; 1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud; Individual signal generator per port, allowing simultaneous firing of all ports | |
I/O Versiports 1 - 4 | (1) 5-pin 3.5mm detachable terminal block comprising (4) digital input/output or analog input ports (referenced to GND); Digital Input: Rated for 0-24 Volts DC, input impedance 20k ohms, logic threshold 1.24 Volts DC; Digital Output: 250mA sink from maximum 24 Volts DC, catch diodes for use with “real world” loads; Analog Input: Rated for 0-10 Volts DC, protected to 24 Volts DC maximum, input impedance 20k ohms; Programmable 5 Volts, 2k ohms pull-up resistor per pin | |
RELAY OUTPUT 1 - 4 | (1) 8-pin 3.5mm detachable terminal block comprising (4) normally open, isolated relays; Rated 1 Amp, 30 Volts AC/DC; MOV arc suppression across contacts | |
IR IN | (1) 3-pin 3.5mm detachable terminal block; For connection of the CNXRMIRD IR Receiver (sold separately); Allows IR wireless control from Crestron or third-party remotes using RC-5 IR commands | |
ANTENNA | (1) BNC female, connection for supplied antenna or optional high-performance antenna (CNANT sold separately); Impedance: 50 Ohms | |
COMPUTER | (1) DB9 female, RS-232 computer console port | |
NET | (1) 4-pin 3.5mm detachable terminal block; Cresnet port, Master/Slave selectable; Expandable via C2N-NPA8 Network Poll Accelerator | |
24VDC | (1) 2.1mm barrel DC power jack, 24 Volt DC power input; (PW-2420RU power pack included); Passes through to NET port to power Cresnet devices | |
Reset Buttons | ||
HW-R | Hardware reset (reboots the control system) | |
SW-R | Software reset (restarts the SIMPL program) | |
LED Indicators | ||
PWR | (1 green) Indicates DC power supplied to unit | |
NET | (1 yellow) Indicates Cresnet bus activity | |
MSG | (1 red) Indicates control system has generated an error message | |
SIG | (1 red) Indicates RF communication with a Crestron transmitter | |
Power Requirements | ||
Power Pack | 2.0 Amps @ 24 Volts DC; 100-240 Volts AC, 50/60 Hz power pack, model PW-2420RU included | |
Available Cresnet Power | 38 Watts using PW-2420RU power pack (included) | |
Cresnet Power Usage | 12 Watts (0.5 Amp @ 24 Volts DC) using Cresnet network power (no power pack connected to the 24VDC connector) | |
Environmental | ||
Temperature | 41° to 113°F (5° to 45°C) | |
Humidity | 10% to 90% RH (non-condensing) | |
Enclosure | ||
Chassis | Metal, black matte finish | |
Faceplate | Extruded aluminum, black matte finish with polycarbonate label overlay | |
Mounting | Freestanding or 1U 19-inch rack-mountable (adhesive feet and rack ears included)[1] | |
Dimensions | ||
Height | 1.80 in (46 mm); 1.70 in (44 mm) without feet | |
Width | 17.03 in (433 mm); 19.0 in (483 mm) with ears | |
Depth | 9.07 in (231 mm) | |
Weight | ||
4.3 lb (2.0 kg) |